76570EM 29
9. [ADJ.] Shutter Speed (1/4000sec.)
*Measure the shutter speed according to the following points whenever 0-E000 or 0-T100 is
replaced.
*If using reflection type of shutter tester, skip this adjustment and adjust at [21.ADJUSTMENT
with Programmed Software (SLR operation)] section.
[Required equipment] Programmed software 76570 (for SLR operation), Computer and related
items, I/F buffer cable for 27250 (MZ-5),SD card (For test mode ON), Shutter tester (measurable
1/4000), AC adaptor, Flexible board for 76450, Two lead wires (130mm),
Shutter attachment 76180, refer to the Information of Jigs, Tools and Testers for *istDS
DC code, Regulated DC power supply (8V/3A), Circuit tester, TV monitor Video cable.
[Caution] Do not touch the shutter curtain from this point.
9-1. Preparation 1
(1) Install temporally test bottom cover.
(2) Solder the lead wires from I/F buffer cable for 27250 (MZ-5) as shown
figure right.
(3) Solder the two lead wires to T100 and mirror motor lead wires
(Black and red) as shown figure below.
(4) Connect two flexible boards to T100 and T200.
[Caution] Do not stress to the flexible boards.
(5) Solder Main SW land on T200.
(6) If using sensor head type tester, put shutter attachment to
the body (Rear side) align with post.
White (14p)
Yellow (19p)
Red (17p)
Brown (16p)
Orange (18p)
③
⑤
⑥
⑤
⑤
③
Main SW
Land
④
