76570EM 23
11-2. Adjustment
Set the test mode to disable SD card cover switch on T100.
(1) Insert SD card for test mode ON to T100. (Set write protect switch to unlock position)
(2) Connect DC code to T100. Make sure there is no short circuit.
(Consumption current: 100~200mA)
(3) Connect the resistor within seven second from section (2).Viewfinder indication will be all ON.
If indication is not all ON: 1. Disconnect DC code and remove SD card then disconnect resistor.
2. Again, connect DC code to T100 and connect the resistor within
five second.
* If viewfinder indication dose not display and guide screen or menu (Fn) screen is displayed,
execute above 1. and 2. again.
(4) [CONF] Confirm position of the viewfinder display as shown figure below.
(5) [ADJ]
Loosen screws and adjust the position. After adjust, apply screw lock.
(6) Disconnect DC code and resistor.
*Cancel the test mode with below method.
(7) Insert SD card for test mode OFF to T100.
(8) Connect DC code to T100. (If Consumption current is zero, cancellation is completed. It takes 9
second).
(9) Disconnect all connection and temporary soldered one lead wire.
(4)
(5)
SL
SD memory card
DC IN ⇒
①
②
