19
Installation and User’s Guide
POOL
IDLE/HEAT/COOL
SET=__ ACT=__
SPA
IDLE/HEAT/COOL
SET=__ ACT=__
PENTAIR WATER
HEAT PUMP OFF
AUTO MODE
POOL/SPA
CONTROL PANEL OPERATION
1.
Starting and Stopping the Heat Pump
– The heat pump is started and stopped with the ON/OFF button.
a. Starting - If power is supplied to the heat pump and the ON light is not illuminated, pressing the
ON/OFF button will start the heat pump which causes the ON light to illuminate.
b. Stopping - If the ON light is illuminated, pressing the ON/OFF button will stop the heat pump causing
the ON light to be extinguished. The screen shown below will be displayed temporarily.
2.
Changing the Set Point
– The control board has 2 independently adjustable temperature set points. One
set point is for the pool temperature control and the other for temperature control of the spa. The active mode
of operation (pool or spa) is defined as the "active" set point.
a. The value of the pool or spa temperature set point is adjusted by pressing the UP or DOWN arrow
buttons when the associated pool or spa run screen is displayed. The temperature set point is displayed
after the letters SET in the lower left corner of the display. The number after ACT= on the bottom row
is the actual measured water temperature.
b. The set point need not be active to be adjusted. Press the MENU SELECT button repeatedly until
the associated run screen is displayed. With that screen displayed, adjust the set point with the UP
and DOWN arrows. The screen will automatically return to the active run screen after 15 seconds of
keypad inactivity.
c. The active set point can be changed in one of the following two ways:
i.
On the first press of the POOL/SPA button the current heat, cool or auto mode will be displayed
along with whether the pool or spa set point is active. On subsequent presses, the use of the pool
or spa set points will be toggled. The operator can also toggle between the pool and spa set point
by using the UP and DOWN arrows when this screen is displayed.
ii. The Auto Mode screen can also be made active by repeatedly pressing the MENU SELECT
button. Once the Auto Mode screen is displayed the active set point can be toggled between
pool and spa by pressing the UP or DOWN arrows.