Pentair Intellitouch ScreenLogic, User Manual

Page: 67 / 116

57
IntelliTouch ScreenLogic User’s Guide
Main Screen
The Pool/Spa Main screen displays the main control buttons for the pool, spa, and user defined water features.
Pool control button: Switches on Filter Pump and fires heater.
Shared equipment systems (i5, i7+3, i9+3); rotates valves to
pool position.
For shared equipment: When both Heat Mode buttons for the
pool and spa are set to on, if the Pool button is switched on, the
Spa button is off. The Heat Status display indicates that heat is
switched off to the spa while it is being used to heat the pool.
This button by default is always displayed on the Main tab.
To assign circuit buttons, see “Setup Circuits,” page 35.
Pool/Spa heat controls: The Heat
Mode switches control the current
heat source being used.
Actual Temp displays the current
temperature of the pool/spa water
via the water temperature sensor.
Set Point displays the current
temperature that the heater is set to.
Spa control buttons: For
shared (i5, i7+3, i9+3) and dual
(i10+3D) equipment systems;
switches on filter pump, rotate
valve actuator (to isolate spa
water from pool water), and fires
heater.
Water Feature buttons: These
buttons are user defined
circuits. To assign circuit
buttons, see “Setup Circuits,”
page 35.
Tabs:
Lights:
Control your pool, spa, and landscape
lighting from this screen, see pages 60 and 61.
Schedule: Program pool, spa and lighting
schedules from this screen, see page 69.
History: View historical usage data for your pool,
spa, lights and solar, see page 75.
Equipment: Displays general system errors,
chlorinator controls, system delays and spa-side
enable/disable controls, see page 76.
Yellow/Grey button: A yellow
button indicates that the circuit
is switched On . A grey button
indicates that the circuit is
switched Off . Tap the button to
switch a circuit on, then tap it
again to switch it off.
Default Home Screen: After five
minutes, if there is no activity,
the Home screen will be
displayed.