Pentair Intellitouch ScreenLogic, User Manual

Page: 82 / 116

72
IntelliTouch ScreenLogic User’s Guide
Run-Once Timer
Use the Run-Once timer feature to program a circuit to automatically switch equipment on for one time. Unlike the
Schedule regular timer, this once-only timer does not repeat. For example, you could set up the program to pre-
heat your spa ready for your arrival. After the programmed Run-Once circuit is completed, it is automatically
erased. The circuit must be turned off manually or wait for the 12 hour automatic shut off. However, the 12 hour
factory shut off time can be changed by setting a new run time in the Egg Timer. See “Egg Timer Screen,” page 73.
To program a Run-Once daily timed circuit:
1. From the main screen, tap the Schedule tab.
2. Tap the Run-Once tab.
3. Tap the Add Program button to add a new program.
4. Assign a circuit: Tap either side arrow to scroll through the available circuits. Select the circuit to schedule.
After you have finished configuring the programs in this screen, the pool, spa, and lights circuits will be
displayed in groups in the status list (i.e., all pool programs are displayed together).
5. Set the start time: Tap either side arrow to set the hour for the start time.
6. Set the stop time: Tap either side arrow to set the hour for the stop time.
7. Heat Command: Tap either side arrow to set the heat mode. The options are The options are Don't Change
(default), Off, H.Pump Only, H.Pump Preferred, and Heater. If “Solar present” is selected (see page 43) the
options are, Don't Change, Off, Solar Only, and Solar Preferred. Use the Don't Change option to use the
currently selected Heat Mode option on the Main screen. Use the side arrows to select the heat mode.
8. Change Heat Set Point: Options are: Use Manual Setting (default), and Yes. Use either side arrow to select
the option. To change the existing heat set point select Yes and change the new set point in Heat Set Point
option.
9. Heat Set Point: This option displays if Yes is selected in Change Heat Set Point. Tap either side arrow to set
the new heat set point.
10. SmartStart: Select Yes to enable the option. This option displays when a S Am or S AL light circuit is
selected in the Circuit option. If the SAM or SAL circuit was assigned a color changing light Circuit Function,
when it is switched on in the Lights screen, the color lights will automatically begin changing colors.
11. Days: To set the timer to work on a particular day, tap the day to run the schedule.
12. To create another schedule, tap Add Program .
13. To delete a program: Select the program to delete from the list, and tap Delete Program .
Note: If Manual Operating Priority is enabled during a scheduled run time, the scheduled run time is reset
to 12 hours (default). For more information about the General Settings option “Manual OP Priority,” see
page 33.