![background image](http://html.mh-extra.com/html/pentair/genesis-hb16/genesis-hb16_instruction-manual_1524267006.webp)
© 2013 Pentair Equipment Protection
87976428
- 6 -
INSTALLATION INSTRUCTIONS
MOUNTING INSIDE OF THE ENCLOSURE
1. Slide rails must be provided for supporting the rear portion of the air conditioner. Do not
depend on the units mounting flange to support the entire weight. For mounting opening cutout
dimensions, see Figure 2.
2. To protect the integrity of the closed-loop design (see PRINCIPLES OF OPERATION, page 8),
adhesive backed gasket tape is provided (shipped loose) for sealing around the enclosures air
conditioner mounting opening. The gasket tape may be cut to length and either adhered to the air
conditioner or to the enclosure as preferred.
3. The hot condenser air from the rear of the air conditioner must be ducted out of the enclosure.
Openings and/or ducting must be of sufficient size to handle the air flow (25 in.
2
minimum). Keep
in mind that reduction of air flow will impair air conditioner performance. Also remember that this
air is hot and relatively dirty, therefore cracks and joints must be adequately sealed.
4. The drain tube which exits at the side of the air conditioner must be routed to the exterior of the
enclosure. A copper “P” trap has been included in the drain system and must be properly primed
and installed to prevent counter air flow into the drain system. A pressure relief fitting is also
provided to vent any air blockage that may prevent proper drainage. The drain outlet must not be
submerged nor any portion of the drain system elevated above the exit point of the air conditioner
or overflowing of the condensate pan may occur.
5. Use of extension cords is not recommended.
Mounted Inside Enclosure
Figure 1
Cutout Dimensions for NEMA 12 Enclosures
Dashed Lines Repersent Air Conditioner
Figure 2
Summary of Contents for Genesis HB16
