QuickTouch
®
II Wireless Remote Installation and User’s Guide
5
QuickTouch II Wireless Remote kit contents
•
QuickTouch II wireless remote (P/N 520018)
•
Receiver (with 9½ ft. cable)
•
Plastic anchors (qty.4) for mounting Receiver to concrete or stucco
walls
•
Mounting screws (qty. 4) for mounting the receiver to a flat surface
•
User’s and Installation Guide (this manual)
What to do if the remote is submerged in water:
The QuickTouch II wireless remote
is water resistant and can be exposed to temporary splashing or wet hands. However,
the remote is not intended to be submersed. Remove remote immediately if it’s
dropped in the water or exposed to rain. If accidental submersion occurs, remove the
battery cover and remove the battery from the remote. Dry the remote and battery with
a dry cloth and let the water drain out of the remote. Install the battery and battery
cover when completely dry. Store the remote indoors in a dry environment.
QuickTouch II Wireless Remote Overview
The QuickTouch II wireless remote remote is a double-insulated device for use with
EasyTouch
®
, IntelliTouch
®
, SunTouch
®
and Compool (CPxxxx) pool and spa control
systems. EasyTouch, IntelliTouch, SunTouch and Compool control systems supports one
QuickTouch II wireless remote per system. The QuickTouch II wireless remote may be
used with wet hands. To aviod damage to the remote, never submerge in water. The
MobileTouch wireless controller is water resistant and can be exposed to temporary
splashing or wet hands. However, the controller is not intended to be submersed.
Remove unit immediately if it is dropped in the water or exposed to rain. Store the unit
indoors in a dry environment. Be sure the gold charging contacts are dry before
charging.
Upgrading QuickTouch 4 (QT4) Wireless Remote:
The Pentair Water Pool and Spa
®
QT4 can be upgraded with the QuickTouch II wireless remote.
Use the QuickTouch II wireless remote to activate the spa circulation, and to operate
three auxiliary pieces of equipment (such as lights, jet pump, air blower, waterfall, etc.).
The remote button can be configured to duplicate any four circuits functions. To
activate a circuit functin, press and hold the circuit "ON" button for at least a full
second. To switch a circuit off, press and hold the “OFF” button.
The remote has four buttons to switch each circuit function "ON" and “OFF”. Each of the
four buttons can be assigned to control any circuit funtion. The factory preset button
assignments are:
Spa button (#1):
Activates the spa circuit.
Button 2:
Activates auxiliary 2 circuit.
Button 3:
Activates auxiliary 3 circuit.
Button 4:
Activates auxiliary 4 circuit.
QuickTouch II Antenna Receiver Location
The QuickTouch II wireless remote has an operating range of up to 500 ft. from the
QuickTouch II antenna receiver, which is typically located near the load center. The
optimum wireless transmit and receive range may be affected by physical obstructions,
(especially those containing metal), and geographical features.
Pool button (#5):
Activates the pool circuit.
Button 6:
Activates auxiliary 6 circuit.
Button 7:
Activates auxiliary 7 circuit.
Button 8:
Activates auxiliary 8 circuit.
