QuickTouch
®
II Wireless Remote Installation and User’s Guide
18
Connecting the spa-side remote to a CP3xxx load center using
adapter
Strip back the cable 1-inch and ends of leads ¼-inch. Open the cable adapter (P/N
520000, included in kit). Insert the spa-side remote cable into the adapter and attach
wires to the terminals (see the wiring diagram below). Attach the six conductor flat cable
pig-tail between cable adapter and the COM port connector on the circuit board in the
Compool load center.
Upgrading from the Compool SS8 to the Spa-Side Remote
The spa-side remote may be used to replace the SS8 spa-side remote on the CP3xxx
family of systems. Note: The spa-side remote can still only control up to eight functions.
Note: The SS8 must also have been plumbed with a minimum 1-inch conduit.
Remove SS8 Remote
Unplug the SS8 from the load center then pull out the unit from spa-side location.
Remove the SS8 mounting bracket from spa-side location (two screws). All that should
be left is a minimum of 1-inch. diameter conduit.
Install the Spa-Side Remote
For spa-side remote installation instructions, see page 8-9).
Controller Adapter
RED
YEL
YEL
RED
GRN
GRN
BLK
WHT
WIRING
Spa-Side Remote Wiring
Diagram
Compool connector block with cables
COMPOOL SS8 REMOTE UPGRADE INSTALLATION
SpaCommand Spa-Side Remote Replaceable Parts List
