QuickTouch
®
II Wireless Remote Installation and User’s Guide
11
8.
Close the control panel and secure it with the two access screws.
9.
Install the high voltage panel cover and secure it with the two retaining
screws.
10. Close the load center front door and secure with the two latches.
11. Switch power on to the load center.
12. For spa-side remote IntelliTouch setup information, refer to “Adding a Spa-
Side Remote to IntelliTouch,” on page 15.
BLK
GRN
YEL
RED
IntelliTouch Personality
board COM ports
(J7/J8)
EasyTouch circuit board
EasyTouch Circuit Board
5.
Insert the four-wire cable into the plastic grommet on the bottom of the
enclosure and route the wire up through the low voltage raceway to the main
circuit board.
6.
Strip back the cable jacket 1-inch and the cable conductors ¼-inch.
7.
EasyTouch System:
Insert the wires into the COM PORT
(J20)
screw
terminals located on the top of the EasyTouch circuit board (see diagram
below). Secure the wires with the screws. For wiring details, refer to the pin
configuration shown below. Note: Multiple wires may be inserted into a single
screw terminal.
IntelliTouch System:
Insert the wires into the either of the COM PORTS
(J7
and J8)
screw terminals located on the left side of the Personality board.
Secure the wires with the screws. For wiring details, refer to the pin
configuration shown below. Note: Multiple wires may be inserted into a single
screw terminal.
IntelliTouch Personality
Circuit Board
COM port
