Pentair Flotec DIGIPRESS, Use And Maintenance Manual

Page: 17 / 78

USE AND MAINTENANCE MANUAL
EN
15
CHAPTER 6
STARTING UP
1. Start the device pressing
2. Introduce the nominal pump
current:
- Press and hold for 3
seconds.
- We view on the intermittent
screen the nominal current with
the ON led.
- Via the keys and adjust the
nominal current indicated on the
pump plate. See Note 1.
- Press to validate.
• Press + for 5 seconds.
•
Use the keys or to modify
the values.
3. Introduce operating pressure:
- Press for 2 seconds.
- We view start pressure
flashing and the
- START ON led.
- Via the keys and adjust
the start pressure from 0.5 to
7 bar.
- Press to validate.
4. Introduce stop pressure:
- Press for 3 seconds.
- We view on the screen the stop
• Press to validate and to move
to the next one.
pressure flashing and the STOP
ON led.
- Via the keys and adjust
the stopping pressure from 1
to 8 bar.
- Press to validate.
5. I device remains configured and
ready for use.
•
The sequence of parameters is
as follows:
Before starting up the device it is necessary to read the previous points, especially "Hydraulic System" and
"Electrical Installation".
DANGER
NOTE 1
BASIC PROGRAMMING MENU
it is very important to introduce exactly the nominal current on the pump specifications plate.
Basic operational start-up consists of:
• Press + + for 5 seconds.
•
Use the keys or to modify
the values.
• Press to validate and to move
to the next parameter.
•
The sequence of parameters is
as follows:
ADVANCED PROGRAMMING MENU
IT TYPE SYSTEM REACTION
DEFAULT
SETTING
1
BAR P It allows selection of the units in which
the pressure between bar and psi is displayed bar
2
rc0 rc1 Rapid cycles alarm:
- rc0: deactivated.
- rc1: alarm activated, when it is detected, a delay is produced in start-up to protect the
pump.
- rc2: alarm activated, the pump stops when it is detected.
rc0
3
r.01 r. 99 If the rapid alarm cycles are activated in the previous point (rc1), we can select the
period of time between 3 consecutive start-ups, in seconds. We consider as rapid cycle
between 1" and 99". 5 seconds
4 Sb0 Sb1 Allows activation or deactivation of the display standby mode (Sb1) (Sb0) to save energy. Sb0