
SPEED %
HOME
Z
ZERO
GO TO
A
BEND
X
STOP
Shows the speed the machine is
running as a percent of the maximum
speed determined by machine settings
Commands the D.I.Wire to locate and
rest at Home (machine position zero)
Controls the up/down position of the pin
Sets the current position of the
specified axis to 0
Go to the position entered in the jog bar
Controls position of the bend pin,
measured in degrees
This may be helpful for loading wire
The machine must be homed when
turning on the machine or restarting
or if it has lost its location
Starts bending the active path
Controls the feed of the wire, measured in
the units in use (inches or mm)
Immediately stops moving the machine
axes
Jog controls the machine with simple
movements set in the numerical fields for
each moving part of the machine
HOME, BEND & STOP
JOG
Control & Jog Bar
The Control Bar and Jog Bar at the bottom of the workspace can be found
in every mode. These controls are
Home
the bend pin,
Bend
the path, and
Stop
the D.I.Wire. The Jog bar shows the location and controls to move the
bend pin and feed wheels.
04 | PATH MODE
31
Summary of Contents for D.I.Wire Pro
