Hardware Operations
1230B0026701
2-6
Before you install or remove the processor, make sure the power is off. To power off the
server, see “2.1.1 Power Off” in the Chassis User Manual.
Reminder
Before you remove or install heat sink, processor or heat sink socket, please follow the steps below:
Step 1: Make sure the server is not turned on or connected to the AC power. To power off the server,
see “2.1.1 Power Off” in the Chassis User Manual.
Step 2: Remove the chassis cover. To remove the cover, see “2.2 Chassis Cover” in the Chassis User
Manual.
Step 3: Disconnect all necessary cable connections.
2.4.1 To remove the heat sink
Rotate to release the lever.
Tilt the heat sink.
Pull up the heat sink from the installed processor.
Figure 2-6 Pulling up the Heat Sink
2.4.2 To install the heat sink
Reverse the steps above to install the heat sink.
Before you put the heat sink on top of the installed processor, please do not forget to check if
the grease is complete on bottom of the heat sink.
