Pelton & Crane Helios HL3CB, Installation Manual

Page: 34 / 44

34
053154 r17
eleCTRICal ConneCTIons CeIlInG, Wall, TRaCK, CabIneT
1. A terminal block is supplied with these
configurations for connection of the main power
supply.
noTe: For electrical supply connection, use wiring
suitable for at least 90°C (194°F).
noTe: The maximum ceiling height the light may be
mounted to is 10 ft.*
2. Ensure green/yellow ground wire is grounded at
ground screw.
3. Install wall switch between power supply and light
power supply transformer. This provides for safety
and convenience during installation or service. Wall
switch can be switched OFF during electrical storms
to prevent transformer damage caused by voltage
overloads.
* If installing a monitor, see Monitor Installation Manual
for correct ceiling height.
WaRnInG: Connections to be performed
only by a qualified electrician.
TeCHnICal DaTa
POWER SUPPLY
Primary Specifications for Transformer
Volts Cycles Amps
115 VAC 50/60 Hz. 1.0 A ~
230 VAC 50/60 Hz. 0.6 A ~
Secondary POWER SUPPLY
Volts Cycles Amps
24 VAC 50/60 HZ 2.0 A
WaRnInG: Before making any
connections, be sure all power has
been disconnected. Making connections
while chair or unit is connected to power
source may result in equipment damage
or injury.
WaRnInG: Make sure main power is OFF
when connecting to terminal strip.
For replacement fuses use:
054926 1.0 amp fuse
053199 0.6 amp fuse
P/N 055335 Rev.00
WIRING
DIAGRAM
FOR
LED
LIGHT
4"
B
L
U
E
4"
0.6A FUSE
L
0.6AFUSE
TRANSFORMER
4" BLACK
6" BROWN
6" BLUE
6" BLUE
6" BROWN
6" GRN/YEL
4" 4"
TRANSFORMER TERMINALS
6 12
11 5
2 8
7 1
L
L
*230V U.S.A.
G
*
*
*
230V INTERNATIONAL
4" 4"
B
O
4" BLUE
6" GRN/YEL
6" BROWN
6" BLUE
6" BLUE
6" BROWN
1A FUSE
L
2
TRANSFORMER
8
6
11
5
7 1
12
4"BLACK
TRANSFORMER TERMINALS
115V STANDARD
1.ADD SECOND FUSE HOLDER.
2.ADD 0.6A FUSE(313.600).
3 ADD 4" BLUE WIRE.
3.CHANGE LABEL.
BLACK
FROM
LE
DT
RIPOD
WHITE
FROM
LE
DT
RIPOD
BLACK
FROM
LE
DT
RIPOD
WHITE
FROM
LE
DT
RIPOD
B
R
O
W
N
B
R
O
W
N
B
L
U
E
G
N
N
L