18
053154 r17
Track light installation (see page 13 for Illustration)
1. Remove the adapter from the column and set
aside.
2. Feed power cable from trolley through the column.
Apply grease (
*
) to threads on column. Thread
column onto trolley.
3. Insert and tighten two set screws (found within the
hardware kit sent inside the column) in trolley to
secure column.
4. Using 5/64 Allen Wrench, loosen the two upper set
screws on adapter.
5. Apply grease (
*
) to threads on column. Thread
Adapter onto Column and apply Magnalube grease
(
*
) to stem.
6. Connect wire from Trolley to wire in Flex Arm, push
the QC Collar to the installation position and install
Stem into Knuckle while pushing wires into Column.
TRaCK & TRolley HelIos InsTallaTIon
7. Align rotational stop pin (located on flex arm
knuckle) with vertical alignment sticker on hub.
Slide flex arm knuckle up onto stem until the
two clamps in the Knuckle snap into place in the
groove on the Stem. Pull the QC Collar to the
locked position (it must fully cover the clamps in
the Knuckle).
8. Ensure rotational stop is in correct position, and
tighten set screws on adapter.
9. Locate two 3/32” pilot holes on the trolley and the
adapter; using the supplied drill bit with stop, drill
1/8” hole to a depth of 5/8”. Insert roll pins (found
within the hardware kit sent inside the column).
See Maintenance & Adjustments for final installation;
Check Light for Operation.
Upper
Position
Lower
Position
C
L
'A'
64”
81-1/4”
FLOOR
LIGHT
CEILING
'B'
350°
Ceiling
Height from
Floor
Column Set
Assy. (P/N)
"B" & "C"
Column
Length
Column
Assy (P/N)
'A'
'B'
8' (96")
053933
14"
3324030GY
8-1/2' (102")
053934
20"
016919GY
9' (108")
053935
26"
016920GY
9-1/2' (114")
053937
38"
016922GY
Ceiling Height
Helios Flex Arm
016921GY
32"
053936
10' (120")
Minimum ceiling height is 96"
FLOOR
37”
23”
120°
330°
22”
32-3/4”
28”
Summary of Contents for Helios HL3CB
Page 1: ...Installation Manual Helios Light ...
Page 43: ...43 053154 r17 NOTES ...
