Pella
®
Lifestyle Series Motorized, Integrated Blinds and Shades with Insynctive | 11
REPLACING BATTERIES
The battery pack used in this product is recharged by the solar cell or
by using the Pella
®
Lifestyle WALL CHARGER. Battery life is dependent
upon a number of factors such as number of charge/discharge cycles
and average temperature in the environment. Battery life is expected
to exceed five years in most applications. When the battery reaches the
end of its life, it will lose its charge quickly and will require charging with
the wall charger on a more frequent basis. Contact your local Pella sales
representative to purchase a replacement battery.
WARNING:
Batteries carry the risk of fire, explosion and burns. Do
not disassemble or incinerate. Failure to change battery properly
when low will impair BLIND or SHADE performance.
IMPORTANT NOTES:
•
BLIND or SHADE does not need to be paired to REMOTE or BRIDGE
following a battery change.
• Properly dispose of used batteries based on your local requirements.
A best practice is to dispose of batteries at your local home chemical
collection center.
California Only:
Contains perchlorate material.
See dtsc.ca.gov/hazardouswaste/perchlorate for any special
handling regulations.
ADDING AN ADDITIONAL REMOTE OR DELETING A REMOTE
These procedures may be used to pair or delete a REMOTE from
BLIND or SHADE. A total of eight REMOTES may be paired to BLIND
or SHADE.
• Touch the top end of REMOTE to BLIND or SHADE cover
approximately 6" from the end where the wire connects. Move
REMOTE back and forth slowly until BLIND or SHADE completes
a quick up/down motion to indicate that BLIND or SHADE has
entered pair mode.
— To add a new REMOTE, press and hold the Up button on
new REMOTE until BLIND or SHADE completes a quick
up/down motion to acknowledge that new REMOTE was
successfully paired.
— To delete REMOTE, press and hold the Down button on
REMOTE until BLIND or SHADE completes a quick up/down
motion to acknowledge that REMOTE was successfully deleted.
SOLAR
PANEL
COVER
REMOTE
MEASURE 6"
FROM END WHERE
WIRE CONNECTS
BATTERY
Additional Instructions (continued)
