pela tools 514019, Manual

Page: 12 / 32

Transport
When transporting, the machine must be in its
original packaging and placed according to the
mark on the packaging. Because the already
packed machine must be handled with a forklift
with the corresponding tonnage for loading and
unloading. The location for inserting the forks is
shown in the picture.
Unpacking and inspection
Peel off rivets that are attached to the pallet and
loosen the cardboard and plastic covers. Make
sure that all the parts mentioned in the spare parts
list are in the package. If any parts are missing or
damaged, do not use the machine but contact the
distributor immediately.
Workplace requirements
Choose a workplace in accordance with the safety
regulations. Connect the power supply and the air
source according to the operating instructions. The
workplace should be well air-conditioned. In order
for the machine to work, it requires a workplace
with the least space on each side as shown in
Fig. 2. If you install it outdoors, it must be protected
with a roof against rain and sunshine.
Warning: The machine must not be used in an
explosive area.
Location and installation:
1. Preparation of tools.
2. Place the swing hinges on the trunk with 4
screws (M12), thread the air hose through the
hole in the pillar. Tighten 4 locknuts.
3. Insert the bolt (9) into the holes in both the
column and the inclined cylinder arm (11),
tighten it with a lock nut (10).
4. Unscrew the two bolts on the left cover and
remove the cover, connect the air hose (2) as
previously mentioned to the side holes that
guide the inclined 5-branch valve. Replace the
left cover.
5. Fasten the plastic cover (7) with two bolts (4).
Mount the plastic cover (5) with the column
screw (6).
Electrical and pneumatic connections
Warning: Before mounting and connecting, make
sure that the voltage source corresponds to the
technical data of the machine. All electrical and
pneumatic connections must be made by a
professional electrician.
Connect the pneumatic coupling located on the
right side of the machine to the pneumatic
source. The mains to which the machine is
connected must be protected with plugs and
proper grounding. Install the earth leakage circuit
breaker to the main power source. The firing
current must be set to 30 mA.
Warning: The machine has no plug. The user must
install a plug of more than 16 A, which corresponds
to the voltage of the machine.