Page
20
of
46
User Manual PTCarPhone
5
Series
System Menu
NOTE
:
In operation mode
1, 2
and
3
the phone can only be used restrictively. This is a security feature, which is especially
suitable for fleet vehicles as a cost-saving measure.
Changing the Delay Timer
The delay time starts, when the ignition is switched off. If a key on the phone is pressed during the delay time, the
delay timer restarts.
System > Configuration >
device code input
> Delay timer
Options
0
min (the device is powered down, when the ignition is turned off),
5
min,
15
min,
1
h,
2
h,
4
h,
8
h,
12
h,
1
d,
7
d,
10
d
or
30
d (min = minute/s; h = hour/s; d = day/s)
NOTE
:
When the feature Virtual Ignition was activated, the delay time starts after switching off the engine of the vehicle.
Activation of the Virtual Ignition
If the PTCarPhone was installed correctly, it powers up automatically when the ignition of the vehicle is started.
For modern vehicles without ignition wiring, the feature
Virtual Ignition
is intended. The Virtual Ignition detects
changes in the power supply and powers the PTCarPhone up, when the engine is started.
System > Configuration >
device code input
> Virtual Ignition
Options
On:
Automatic detection of the ignition
Off:
Ignition over the true ignition contact (terminal
15)
NOTE
:
This setting needs to be done only once, during the PTCarPhone installation.
Resetting the PTCarPhone to Factory Defaults
System > Configuration >
device code input
> Reset
Options
No, Yes (confirmation message)
CAUTION
:
The phone will be reset to factory defaults. All data and settings stored on the phone will be deleted!
