Page
16
of
46
User Manual PTCarPhone
5
Series
Assembly Instructions
Sequence of Installation
1 .
Become familiar with the connections (see also
“Connection Plan” on page
13
). Disconnect the
negative terminal of the vehicle battery while
following the safety instructions of the vehicle
manufacturer.
2 .
Select the installation locations for the electronics
box, handset, loudspeaker, hands-free microphone
and the antenna(s), paying attention to the cable
lengths and installation instructions and mount
the components.
When drilling holes make sure that the vehicle is
not damaged. Use cable bushings on sharp-edged
holes.
3 .
Install the included hands-free microphone. Make
sure that air flow from the vents is not in the di
-
rection of the microphone. Also refer to “Mounting
locations for the microphone” on page
14 .
Then install the loudspeaker (a good location is
the passenger footwell). During installation of the
microphone and loudspeaker make sure of suffi
-
ciently large spatial separation, to avoid acoustic
feedback.
4 .
Connect the power supply cable (red) on the perma-
nent positive and the ignition input (yellow/black)
to the ignition *, if present. Do not connect the igni-
tion input (yellow/black) onto permanent positive,
since this limits the scope of function of the device
(see also “Changing the Delay Timer” on page
20
).
Connection of the ground cable is done directly
to the vehicle battery, the central ground point
(ground block) or a part of the vehicle body.
* For vehicles without ignition wiring it is recom-
mended at the end of the installation to activate
the “Virtual ignition” function.
5 .
Connect the violet cable with the mute input of
the car radio. This ensures automatic radio mute
switching for incoming and outgoing calls.
6 .
Insulate unused cables so no short circuits can
occur.
7 .
Connect the individual components of the device
with each other using the plug and screw connec-
tions (see connection diagram on page
13) .
8 .
Check the total installation and insert a valid SIM
card. Connect the vehicle battery.
9 .
For vehicles
with ignition wiring
: Turn on the
ignition. The device now turns on and requests the
input of the PIN (if this was not deactivated on the
SIM card).
For vehicles
without ignition wiring
: Turn the
device on with the end key
/
on the handset.
10 .
Enter the PIN. The telephone is now registered in
the network.
11 .
Make a call in order to check the basic functions.
12 .
Check whether there is new software available and
if necessary perform a software update. Download-
ing of software updates can incur costs, depending
on the mobile phone contract.
See also “Performing a Software Update (OTA: Over-
the-Air)” on page
18
.
13 .
If desired, make personal settings on the device
(see chapter “Setting up the PTCarPhone” on page
17)
and finish the installation.
