19
5.2. Fault:
Radial press does not finish the pressing. Mini pressing tongs, adapter
tongs do not close fully.
Cause:
• Battery depleted or defective (REMS
cordless drive units).
• Drive unit defective.
Remedy:
• Charge the battery with the Li-Ion/Ni-Cd
rapid charger or change the battery.
• Have the drive unit checked/repaired by an
authorised REMS customer service
workshop.
5.3. Fault:
REMS Power-Press SE switches of repeatedly at the end of the pressing.
Cause:
• Defective drive unit.
Remedy:
• Have the drive unit checked/repaired by an
authorised REMS customer service
workshop.
5.4. Fault:
A prominent burr is produced on the press fitting when closing the
pressing tongs, Mini pressing tongs, pressing ring or pressing segments.
Cause:
• Damaged or worn pressing tongs, Mini
pressing tongs, pressing ring, pressing
segments or pressing contour.
• Wrong pressing tongs, Mini pressing tongs,
pressing ring (pressing contour, size) or
adapter tongs, adapter tongs Mini inserted.
• Unsuitable matching of press fitting, pipe
and support sleeve.
Remedy:
• Replace the pressing tongs, Mini pressing
tongs, pressing ring with new ones.
• Check the labelling on the pressing tongs,
Mini pressing tongs, pressing ring or
adapter tongs, adapter tongs Mini and
change if necessary.
• Check the compatibility of the press fitting,
pipe and support sleeve. Observe the
installation and assembly instructions of the
manufacturer/supplier of the press fitting
system to be pressed and contact him if
necessary.
5.5. Fault:
Pressing jaws close without load on the pressing tongs.
Cause:
• Pressing tongs, Mini pressing tongs fell to
the floor, compression spring bent.
Remedy:
• Send the pressing tongs, Mini pressing
tongs to an authorised REMS customer
service workshop for inspection.