6
v
Ensure
Carriage Bolts
are inserted through the
SQUARE
holes
on components that need to
be assembled. Attach washer only to end of the Carriage Bolt.
v
Use
Allen Bolts or Hex Bolts
inserted through the
ROUND hole
on components that need to
be assembled.
v
Always wait until all bolts are assembled onto the bench before tightening the bolts. Do not
tighten each bolt right after it is installed
Fasten Nuts and Bolts
Securely tighten all Nuts and Bolts after all
components have been assembled in current and
previous steps.
NOTE: Do not over tighten any component with
pivoting function.
Make sure all pivoting components are able to move
freely.
Do not tighten all Nuts and Bolts in this step.
Weight Plate Installation
Slide weight plates onto Guide Rod from top to
bottom.
The deep groove on each weight plate needs to
face backwards and downwards.
Deep Groove
OPERATION NOTES
Weight Plate Selection
1. Use the Weight Selector Pin to select the number of weight plates to exercise.
2. Do not insert weight selector pin while the weight stack or top plate is in elevated position.
3. Be certain the weight Selector Pin is completely inserted.
