PEGAS-GONDA PEGAS 235, Manual Instructions

Page: 26 / 35

ISO 9001
PEGAS 235 AUTOMAT CNC - 26 - tel.-fax : 00420-544 221 125
tel.
A ) setting of the top working position
-
move the arm 8-10 mm above the
material, loose the bow 3 and turn
the cam CCW until switch 1 is ON
- move the arm to the position about
40 mm above the top working
position, START the machine and
check right position
B ) setting of the underneath working position
- move the bow under the material, loose the screw into the cam and turn
the cam CCW until switch 2 is ON bar stop 2 to the position, where the
terminal switch is connected, follow direction of the arm; lock at this moment
C) control of optimal setting working and underneath position of the arm
-
set the feed regulator for minimum before starting cutting
-
material is fixed in clamping vice outsides the band.
-
press the START button on the keyboard
-
after lift arm stop in work position
Check through-cutting of material. In case not complete cutting set the underneath
working position again.
DESCRIPTION OF PICTURES
FEEDER
1- feeder with the vice
2- vice of feeder
3- support cylinder
– move manually
according to the length of cut
material arresting handel