PEGAS-GONDA PEGAS 235, Manual Instructions

Page: 11 / 35

ISO 9001
PEGAS 235 AUTOMAT CNC - 11 - tel.-fax : 00420-544 221 125
tel.
CUTTING EMULSION
- use only liquids delivered by PEGAS
– GONDA and mix them in recommended
proportions. Pay attention to right placement of the tank for chips and liquid tank. The
capacity of this tank is 15 l.
When operating with cutting emulsion, wear impermeable protecting gloves and
protective glasses. If the liquid got into the eyes, the eyes could be injured.
When stirring the cutting emulsion, pour the concentrate into the water and stir
continuously. All information needed are mentioned directly on the vessel or in covering
documents.
BAND TENSION
The band is stretched well in that moment, when
the pilot light shines green. Stretching of the
band is done by tightening of screw.
CHANGING THE BAND/C
1. Set the turntable of the machine into the
position 0°, the arm into the upper position,
switch the main switch into the position 0°and
pull the main plut out of the wall socket.
2. Pay attention, the guides of the band should be
as near as possible to each other (when
loosening the crank, move the carrying bar with
guide as far as possible from the stretching
pulley.
3. After damping two covers over (main cover and
small cover at front guides) take the band off
from the pulleys and then také it out of guides.
4. Check the position of pulleys and guides
everytime. All parts which contact the band
must be always cleared carefully.
5. Put the new band into the guides gently and
then put in pulleys. Press the band by back of
your hand to attaching of pulleys and tighten a
little (screw 1 by imbus spanner No.6). Check, if the band is placed in good position
to attaching pulleys No.4, if it is inserted well in the guides and check also the
position of band back to guide bearing.
6. Close the cover of band. Plug in, switch the main switch into the position 1.
7.
Start fitting the stretching screw.The band is stretched well at the moment, when
the pilot light shines green.