Peg-Perego GT3, Instructions For Use Manual

Page: 17 / 24

- 17 -
brake cable, slip it into the slot as shown in
the figure.
5 MOUNTING THE REAR WHEELS: To mount the
rear wheels, push them into the openings on
the sides of the stroller and click them into
place (arrow_a).
MOUNTING THE FRONT WHEELS: press the
button on the rear ledge (arrow_b) while
slipping the front wheel into place (arrow_c).
Pull downward on the wheels to make sure
they are securely fastened.
6 BASKET: Press the side buttons (fig_a) to
remove the basket (fig_b) and fit the material.
7 Slide the assembled basket into the housing
(fig_a). Attach it to the clips at the front
(fig_b) and on the sides (fig_c).
8 HOOD: to fit the hood, insert the side
fasteners into the special housings (fig_a),
button the hood to the back of the backrest
(fig_b) and to the inside of the armrests
(fig_c).
9 Lower the braces to stretch the hood (fig_a).
When you lift the movable part of the hood,
you will find a net insert that provides better
ventilation to the baby (fig_b). To remove the
hood, fold the braces, unbutton the hood,
press the side button (fig_c) while slipping
the hood fastener out of its housing (repeat
on the other side).
10 COVER: zip the cover to the footrest (fig_a),
fasten it to the side by the Velcro (fig_b) and
secure it with the button (fig_c).
11 FIVE POINT SAFETY HARNESS: To fasten it,
push the two waist strap buckles (with the
shoulder straps attached – arrow_a) into
the leg divider until they click into place
(arrow_b). To unfasten it, press the round
button in the centre of the buckle (arrow_c)
and pull the waist straps out (arrow_d).
12 To tighten the waist strap, pull on both sides
in the direction of the arrow (arrow_a). To
loosen it, do the opposite. The waist strap can
be tightened as far as the safety lock (fig_b).
13 To adjust the height of the safety harnesses,
release two the buckles on the rear of the
backrest; pull the shoulder straps towards you
(arrow_a) until the buckles are released and
insert them in the backrest loops (arrow_b).
Remove the shoulder straps from the sack
(arrow_c) and insert them in the most
appropriate loop (arrow_d), then re-attach
the two buckles on the rear of the backrest
(arrow_e).
14 BRAKE: to brake the stroller, pull the handle
on the handlebar towards you (arrow_a);
to release the brake, disengage the lever
(arrow_b). Always set the brake when the
stroller is not moving. To adjust the brake and
tighten it, unscrew the adjuster (fig_c) on the
handlebar to the outside. To loosen the brake,
do the opposite.
15 ADJUSTABLE HANDLEBAR: the handlebar on
the stroller is height-adjustable. To adjust
the height of the handlebar, simultaneously
press the side buttons (fig_a) and block the
handlebar in the desired position (fig_b).
16 SAFETY STRAP: The stroller features a safety
strap on the handlebar. This is to be attached
to your wrist, to provide greater safety when
walking.
17 ADJUSTING THE BACKREST: the backrest
of the stroller can be reclined to several
positions. To lower the backrest, lift the
handle (arrow_a) as you recline the backrest
(arrow_b), locking it at the desired position.
To raise it, push the backrest up.
18 ADJUSTING THE FOOTREST: the footrest can
be adjusted to two positions. To lower the
footrest, pull the two side levers downwards
(fig_a) while lowering the footrest (fig_b). To
raise the footrest, lift it upwards until it clicks
into place.
19 FRONT BAR: the practical front bar opens and
closes to make it easier for the child to get in
and out of the stroller when he/she is older.
To open the front bar, press the button
located under the armrest (arrow_a) and
pull the front bar outwards at the same time
(arrow_b). To close the front bar, do the
opposite. The front bar can be removed. The
front bar is also extendible – to extend the
front bar, press the long button located under
the armrest (arrow_c) and pull the front bar
outwards (arrow_d). To shorten the front bar,
press the long button and push the front bar
into the armrest.
20 SIDE CUP HOLDERS: the stroller is equipped
with two side cup holders that fold away or
pull out as necessary. To pull the cup holder
out, turn the upper part upwards (arrow_a)
and lower the bottom part (arrow_b). Turn
the disk outwards (arrow_c) and place your
drink in the holder (fig_d) To close the cup
holder, do the opposite.
21 RAIN CANOPY: fit the rain canopy onto the
stroller and button it on the side to the hood
(fig_a), button the two sides of the rain
canopy elastic to the bottom of the front
frames (fig_b).
22 The practical rain canopy can be lowered and
remains attached to the stroller through the
buttons.
23 POUCH: place the pouch near its own
housings, located on the handlebar, and
fasten it (fig_a). The pouch can be worn as an
accessory using the special belt (fig_b).
24 SWIVELING OR STATIONARY FRONT WHEEL:
to set the front wheel on stationary, turn the
knob to the closed padlock (fig_a). To swivel
the front wheel, turn to the open padlock
(fig_b).
25 AIR PUMP: to inflate the tires, use the pump