Peco 50721201, Operator'S Manual

Page: 6 / 22

Figure 2-1c.
After removing rear chassis of mower (Figures 2-1d and
2-1e), refer to section 2-2 for instructions on mounting
the PTO mount plate assembly.
Figure 2-1d.
Figure 2-1e.
Installation Of The Exhaust Deflector
Shield
With the rear chassis of the mower removed, align the
two holes in the exhaust deflector P#(C0053) with the
two top slots in the chassis (See Figure 2-1f). Insert (2)
tinnerman screws P#(K1092) and fasten using (2) inlet
clamp plates P#(B1668).
Figure 2-1f.
Rotating The Donaldson Air Cleaner
Note : If equipped with a Donaldson air cleaner, unit
must be rotated to make clearance for top main frame
assembly.
To rotate Donaldson air cleaner, loosen bolt on air
cleaner bracket, rotate air cleaner forward as needed for
clearance as shown in Figure 2-1g, and tighten.
9
6
Remove Existing
(2) 3/8”-16 x 1” HHCS
(2) 3/8”-16 Flange Nuts
Rear Chassis Removed
From Mower
PTO Mount Plate Assembly
Rear Chassis
(2) Tinnerman Screws
(2) Inlet Clamp Plates
Exhaust Deflector
Loosen Bolt To Rotate
Air Cleaner
Donaldson Air Cleaner
Rotated To Forward
Position
Figure 2-1g.