Peco 23651201, Operator'S Manual, Page: 40 / 44

40
3. Make sure all shields are in place and in good
condition. Repair or replace any missing or damaged
shields.
4. Perform lubrication per instructions.
deterioration and wear. Inspect the unit for worn or
the component.
Correct any deficiency before continuing operation.
3. Check belt for proper tension.
After Each Use:
decals. Replace any missing or illegible decals.
5. Listen for abnormal sounds, which might indicate
7. Check for wear or deterioration of the upper or lower
hoses. If there are any portions of the hose that have
2. Under normal usage, the collection unit is subject to
repair shall include the component’s current safety
loose parts, damaged bearings, or other damage.
been torn or worn through, replace immediately.
container, underneath the belt shields, and safety
1. Clean all debris from machine especially from the
damaged components. Repair or replace before the
decal specified by the manufacturers to be affixed to
Check the belt tension and inspect the pulley belt for
next use. Any replacement component installed during
6. With the engine off, engage the blower assembly.
cracks or tears.
DOCUMENT THE FOLLOWING INFORMATION FOR FUTURE REFERENCE
Unit Engine Size:__________________________________________________
Unit Serial Number:________________________________________________
Date of purchase:________/________/_________
Dealer/Distributor Name:__________________________________________
Phone Number: ____________________________________________________
Unit Model Number:_______________________________________________
Address: _________________________________ State:_______ Zip:_______
New PECO, Inc.
Phone: 1-800-438-5823 | 828-684-1234
Email: peco@lawnvac.com
10 Walden Dr | Arden, North Carolina 28704
Website: www.lawnvac.com
Fax: 828-684-0858
NOTE: Use only white lithium based grease for
.
Replace the oil using 5.5 oz. of the recommended
Mobilube HD Plus 80W-90 oil. Be sure to not overfill.
Collection system owners should record the name and
telephone number of their Service Center. Your Service
Center will be happy to supply replacement parts,
accessories, and do any service or repairs to your
collection system. If for any reason your Service Center
is unable to service your collection system or supply
replacement parts, contact New PECO, Inc. and include
the following information on the chart below.
Lubrication
contain a greaseable zirc fitting. Newer models
contain maintenance-free bearings and are without
a greasable fitting.
1. On initial use: Grease the fitting on the blower shaft.
NOTE: The following is for older PTO models that
2. Every 25 hours of use: Re-grease the grease fitting.
NOTE: The gearbox is filled with 6.0 oz. of Mobilube
HD Plus 80W-90 oil and permanently sealed. There is
no need for scheduled lubrication. The oil level should
only be checked if a leak is observed or if a change in
gearbox noise is noticed.
Gearbox:
Operators are recommended to check for leaks weekly.
If a leak is observed, both the gasket and the seals are
recommended to be replaced.
Blower Assembly:
lubrication of the shaft on the blower assembly.
SECTION V - PARTS & SERVICE
Parts And Service Information
2019 (v1.0)