Peco 23651201, Operator'S Manual, Page: 26 / 44

26
Align the (4) holes of the Weight Bracket Clamp (Item #3) to the holes in the Dual Weight Bracket Base (Item #2).
Loosely fasten the Weight Bracket Clamp (Item #3) to the Weight Bracket Base (Item #2) using (4) 5/16"-18 x 3" Bolts
(Item #4.1) & (4) 5/16"-18 Ny-Flange Lock Nuts (Item #4.2).
Position the Dual Weight Bracket Base (Item #2) under the caster tubing w/ opening towards caster fork. Next,
position the Weight Bracket Clamp (Item #3) on top of caster tubing w/ opening towards caster fork.
Position the Weight Bracket Base and the Weight Bracket Clamp assembly along the caster tubing to prevent
interference from caster forks or any other objects. Tighten the fasteners in an 'X’ pattern until assembly is firmly
clamped to caster tubing. Do not over tighten, over tightening may result in the bending of the Weight Bracket Clamps
(Item #3).
Weight Kit Installation
Insert (1) Weight (Item #1) Into the Weight Bracket Base (Item #2) & align the holes of the Weight w/ the holes of the
Weight Bracket Base (Item #2). Fasten the Weight (Item #1) to the Weight Bracket Base Using (1) Clevis Pin (Item
#4.3) & (1) Hair Pin Clip (Item #4.4) per weight. Repeat for additional weight. Refer to the Figure Below.
Figure A