Peco 22131501, Operator'S Manual, Page: 31 / 54

31
Throttle Kit Installation (Continued)
With your Throttle Kit installed, you’ll need to route the cable of the Throttle Kit back towards the rear of the Mower.
Refer to Figure C below.
Route Cable
Behind Mower
Route Cable
to Engine Assy
Figure C
Figure D
Next, bring the Cable out from under the Rear Frame Bracket & Engine Mount Arm up to the Engine/Blower/Blade
Assembly. See Figure D.
Finally, place the Throttle control lever into the “STOP” position. Rotate the Engine’s throttle lever to the “STOP”
position. Thread the wire end of the Throttle Cable into the Engine’s throttle lever eyelet and tighten the screw. Fasten
the throttle cable sleeve to the clamp on the Engine throttle. See Figure D.
Rotate the throttle control lever into the “fast” position to check for proper installation. Make sure the Cable does not
interfere with any mower or unit components.
Engine Throttle
Cable Clamp
Engine Throttle
Lever
Engine Drive