Peco 22131501, Operator'S Manual, Page: 17 / 54

17
Blower Cone Installation
Thread (1) 5/16”-18 Jam Nut P#(K0120) onto each end
of (2) 5/16”-18 x 2-1/2” HHCS P#(K0125) as shown in
Figure B.
Now partially thread (1) bolt into each of the two
threaded bosses located on the Blower Housing. Place
8” Blower Cone P#(E6009) so the two tabs line up with
the bolts and tighten completely as shown in Figure C.
Once the (2) bolts are tight, tighten the Jam Nuts against
the threaded boss as shown in Figure D.
Refer to Figure E for proper Blower Cone installation
reference.
(1st) Tighten
Bolt
(2nd) Tighten
Jam Nut
Thread (1) Jam Nut
Onto Each 5/16”-18 Bolt
Figure B
Figure D
Threaded
Boss
Blower
Cone Tab
Figure C
Blower
Cone
Figure E
Engine Drive Assembly Installation
Engine Driven Unit Instructions
First, place (2) Rubber Shock Absorbers (Item #3) on top
of the Engine Mount Arm Assembly (Item #2) aligning
the bolt holes of the Rubber Shock Absorbers to those
on the Engine Mount Arm Assy.
Next, position and place the 6.5HP Engine Assembly
(Item #1) on top of the Shock Absorbers aligning the bolt
holes of all the components.
Finally, secure the Engine by using (4) 5/16”-18 x 2”
HHCS (Item #4) and (4) 5/16”-18 Nyloc Nuts (Item #5).
Refer to Figure A.
Note: Some parts and part features have been hidden
from view for visual clarity.
Figure A
Engine Drive