Peco 22131501, Operator'S Manual, Page: 27 / 54

27
Wire Harness Installation
First, install the PTO Rocker Switch (Item #2) by
positioning it over the Switch Mount Plate (Item #1) and
firmly pressing the Rocker Switch down until it is seated in
place (Refer to Figure A). Next, connect the Wire Harness’
(2) Female Switch Disconnects (Refer to Figure A) to the
PTO Rocker Switch. See Figure E on Page 28 for complete Wiring Diagram.
Then, position the PTO Switch Mount onto the panel Right of the Operator’s seat. Refer to Figure B. Note the
locations of the (2) bolt holes of the Switch Plate and the (2) bolt holes on the panel Right of the Operator’s seat.
Finally, secure the PTO Switch Mount by using (2) 5/16”-18 x 3/4” HHCS P#(K1153) and (2) 5/16”-18 Nyloc Nuts
P#(K1180). See Figure B.
WARNING
!
To Prevent Serious Injury-
Proper Installation Of Safety Interlock Harness
Is Mandatory. Please Check That All Interlock
Points Work Correctly Once Installed.
Figure A
Figure B
(2) 5/16”-18 x 3/4”
HHCS
(2) 5/16”-18 Nyloc
Nuts
PTO Switch Mount
(2) Female Switch Disconnects
to PTO Rocker Switch
PTO-X