6
LINE CORD (120 V PRODUCTS ONLY) (21)
For your safety, we have incorporated a 3-wire line (mains) cable with proper grounding facilities. It is not
advisable to remove the ground pin under any circumstances. If it is necessary to use the equipment without
proper grounding facilities, suitable grounding adaptors should be used. Less noise and greatly reduced shock
hazard exist when the unit is operated with the proper grounded receptacles.
SPEAKER JACKS (22)
Provided for connection of external speakers or speaker enclosure. Minimum total impedance is 2 ohms.
REMOTE SWITCH DIN JACK (23)
Provided for optional footswitch. Allows remote selection of channel select, graphic in/out, and effects loop (post
EQ).
LINE OUT (LOW Z BALANCED) (24)
An XLR jack is provided to route the signal to mixing/recording consoles. This output can be selected pre or post
EQ.
LINE OUT SELECT SWITCH (25)
Allows selection of pre EQ or post EQ to the Low Z balanced line out jack. The “in” position selects pre EQ line
out, and the “out” position selects post EQ line out.
LINE OUT GROUND LIFT SWITCH (26)
Provides ground to be made from the line out jack or lifted to eliminate ground loop from unit and external
source. There may be some situations when audible hum and/or noise will come from the loudspeaker. Select the
ground switch to either the in or out position to minimize the noise.
POWER AMP INPUT (27)
Used to connect line level signal to the power amplifier.
PREAMP OUT (28)
The preamp output can be used to route the amplified signal to a mixing console, tape recorder, etc. Connect the
preamp output using a shielded cable to an input of the tape recorder, mixer, etc. This patch does not affect the
operation of the amplifier.
CROSSOVER (LOW OUT) (29)
Provides a post crossover low-range output signal. Signal level is adjusted by the master volume control and the
crossover balance control.
CROSSOVER (HIGH OUT) (30)
Provides a post crossover high range output signal. Signal level is adjusted by the master volume control and the
crossover balance control.
EFFECTS RETURN (31)
Input for returning signals from external low-level effects or signal processing equipment.
EFFECTS SEND (32)
Output for supplying signals to external low-level effects or signal processing equipment.
EFX LEVEL SWITCH (33)
Selects the effects loop operating level: -10 dBV (3 V RMS) when in low position and 0 dBV (1 V RMS) when in
high position.
