Crossover Slopes:
24 dB/octave (4th order) low pass, 24dB/octave (fourth order) high pass, both with
staggered poles and driver EQ.
Input Connections:
One combo female XLR and 1/4" phone jack providing balanced line-level operation from the 1/4” jack section,
and high-output dynamic microphone operation from the XLR section.
Output Connections:
One male XLR and one 1/4” phone jack. The Thru jacks are intended for the use of linking
multiple PVXp
™
12 enclosures in a line or to provide a feed to a powered subwoofer, or other electronics that
needs to receive a full range version of the input signal.
Enclosure Materials & Finish:
Black ABS plastic with textured surface, black powder-coated perforated grille.
Also available in white.
Mounting provisions:
Unit has two sets of two M10 inserts, one pair on the top, and one pair on the bottom.
Additional mounting points are a set of four M8 inserts on the top, and a set of four on the right side in the
handle recess, and a set of four on the bottom, which use the Peavey Versamount 70+ mounting bracket. Four
rubber feet provide vibration free floor or stage use, and a molded-in stand mounting cup is on the bottom.
Dimensions (H x W x D):
Front: 24.50 in. x 16.10 in. x 15.00 in. 622 mm x 409 mm x 381 mm
Rear: 22.75 in. x 8.75 in. x 15.00 in. 578 mm x 222 mm x 381 mm
Net Weight:
43 lbs. (19.5 kg)
eLectronics AnD AMpLiFier speciFicAtions:
Internal power amplifiers (@120 VAC line):
Total of 800 watts peak available power
Woofer - 650 watts peak available power
Continuous Power*: 325 watts @ less than 1% distortion
Tweeter - 150 watts peak available power
Continuous Power: 75 watts @ less than 1% distortion.
* Before thermal pull-back activates.
Electronic Input Impedance (Nominal):
Line: 2.2 k ohms balanced (1/4"), 10 k ohms unbalanced 1/4"
Mic: 2.2 k ohms balanced (XLR) No phantom power available.
I
nput Sensitivity for Full Output (Level full CW):
1/4” TRS Phone jack – 0.54 V RMS, XLR jack – 0.12 V RMS
Infrasonic filter protection:
36 dB/octave roll-off
Nominal Amplifier Frequency Response:
+0, -3 dB from 20 Hz to 20 kHz
Hum and Noise:
Greater than 90 dB below rated power
DDT
™
Dynamic Range:
Greater than 21 dB
THD and IM:
Typically less than 0.5 %
Damping Factor:
Greater than 100 @ 1000 Hz, 8 Ohms
Power requirements of Peavey PVXp 12 System:
Nominal 370 Watts, 100-120 VAC 50-60 Hz
Summary of Contents for PVXp 12
