Peavey 03617090, Manual

Page: 5 / 12

Then, once the fresh fuse has been put in place, re-insert the fuse tray into the IEC connector assembly, making
sure that the voltage range selection is correct (see above section) and make sure it is fully seated and flush
with the outside of the IEC connector assembly.
IEC POWER CORD CONNECTION (3)
This receptacle is for the IEC line cord (supplied) that provides AC power to the unit. It is very important that
you ensure the PBK15
FM
has the proper AC line voltage supplied. You can change the voltage for your
PBK15
FM
by following the instructions above under the section VOLTAGE SELECTION PROCESS.
Please read this guide carefully to ensure your personal safety as well as the safety of your equipment. Never
break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a
ground pin, a suitable grounding adapter should be used and the third wire should be grounded properly. To
prevent the risk of shock or fire hazard, always be sure that the mixer and all other associated equipment are
properly grounded.
External power (4)
External battery supply 12VDC
Battery charging indication(5)
CONSTANT VOLTAGE CHA R GE CYCLE USE : 14.5 - 14.9V
STANDBY USE : 13.5 - 13.8V
INITIAL CURRENT : LESS THAN 2.1A
WIRELESS MICROPHONES(6)
Press ON/OFF switch, PWR indicator light, The wireless receiver module is working.
PEAK(7)
Indicator cavity peak signal.Ignition to detect an input signal with a high or high output level that may cause a failure
POWER LED (8)
Illuminates green when the power switch is on and power is present
MASTER VOLUME CONTROL (9)
It is used to directly set the system output level for a given set of input channel input signals
ECHO CONTROL (10)
This controls the amount of Echo effect that is added back to the output signal.
BASS CONTROL (11)
The Bass control provides a boost or cut of lower frequency content, such as bass guitar, so that the tonal
balance can be adjusted depending on the signal source. Do not use excessive boost when playing sound at
loud levels, as the boost is not needed then.
TREBLE CONTROL (12)
The Treble control provides a boost or cut of higher frequency content, such as cymbals, so that the tonal
balance can be adjusted depending on the signal source. Do not use excessive boost when playing sound at
loud levels, as the boost is not needed then.
LINE LEVEL INPUTS (13)
The line-level inputs are of the medium impedance type. A pair of RCA phono connectors is available. Note the
RCA jacks do not denote stereo operation, the signal from both jacks is summed together into one signal that is
fed to the speakers.