Pearson P31-II, Manual

Page: 22 / 82

22
22
YACHT SYSTEMS - SPARS AND RIGGING
SECTION 3
3.1 MAST.
3.1.1 Familiarize yourself with the Masthead Assembly diagram.
(Fig. 3.1.1)
3.1.2 Spreaders And Standing Rigging (Fig. 3.1.2)
The standing rigging consists of a single spreader system,
with single upper and double lower shrouds secured to
chainplates athwartship of the mast; a headstay to provide
forward support for the mast as well as support for the
headsail; and a backstay. (See Fig. 3.1.3).
3.2 BOOM
3.2.1 Follow the Continuous Line Reefing instructions (fig. 3.2.1)
3.3
DOCKSIDE TUNING
Your Pearson is delivered in as near ready - to sail condi-
tion as possible with all basic tuning completed at time of
commissioning. However, a basic tuning procedure has been
included in this section to assist the owner in the future.
3.3.1 Before Mast Is Stepped (Fig. 3.3.1)
Make certain that the headstay, backstay, topping lift,
upper and lower shrouds are connected to the mast. Note
that toggles must be used when connecting the stays to the
mast. Make certain that the headstay also has a toggle at
the lower end.
Adjust all turnbuckles to their extended position to
facilitate attachment when the mast is stepped. Make
certain that each turnbuckle is installed with the
clockwise threads in what will be the down position when
the turnbuckle is in place.
Check the operation of any masthead-mounted instrumentation
as well as masthead, anchor, or spreader lights. If a flag
halyard is desired, it should be rigged now. VHS antenna
should be installed.
Ensure that all shrouds and stays. are properly secured to
the mast with all cotter pins and chafe points taped.
On centerboard models, prepare the centerboard pennant to
be passed through the hole at the base of the mast as the
mast is being stepped on deck.