6.4. Capacitance measurements
Warning!
To avoid electric shock, disconnect power to the unit under
test and discharge all capacitors before taking any
capacitance measurements. Remove the batteries and
unplug the line cords.
1. Set the function switch to the CAP position.
2. Plug the black
test lead into your meter’s COM terminal
and
the
red
test
lead
into
your
meter’s
V/
/CAP/Hz/Temp.- terminal.
3. Touch the test leads to the capacitor to be tested. The
display will indicate the proper decimal point value.
6.5. Temperature measurements
Warning!
To avoid electric shock, disconnect both test probes from any
source
of
voltage
before
making
a
temperature
measurement.
1. If you wish to measure temperature in °F, set the function
switch to the °F range. If you wish to measure
temperature in °C, set the function switch to the °C
range.
2. Insert the Temperature probe into the negative (-) jack
(COM) and the positive (+) jack (Temperature), making
sure to observe the correct polarity.
3. Touch the Temperature probe head to the part whose
temperature you wish to measure. Keep the probe
touching the part under test until the reading stabilizes
(about 30 seconds).
4. Read the temperature in the display. The digital reading
will indicate the proper decimal point and value.
-41-
Summary of Contents for 3335
