* Do not modify the equipment in any way
* Opening the equipment and service
– and repair work must
only be performed by qualified service personnel
*
Measuring instruments don’t belong to children hands.
CAUTION!
Note on using the supplied safety test leads according the
IEC / EN 61010-031:2008:
Measurements in the field of overvoltage category CAT I or
CAT II can be performed with test leads without sleeves with
a maximum of up to 18 mm long, touchable metallic probe,
whereas for measurements in the field of overvoltage
category CAT III or CAT IV test leads with put on sleeves,
printed with CAT III and CAT IV must be used, and therefore
the touchable and conductive part of the probes have only
max. 4 mm of length.
1.1. Safety Symbols
The following symbols are imprinted on the front panel of the
meter to remind you of measurement limitations and safety.
20 A
The maximum current that you can measure at this
terminal is 20 A DC/AC. This terminal is fuse pro-
tected by F 20 A/250 V fuse. When using this range
with high current, keep the duty cycle to 30 sec. on
load and 15 minutes off load.
mA
The maximum current that you can measure with
this terminal is 200 mA that is fuse protected by
200 mA/ 250 V fuse.
Max.
To avoid electrical shock or instrument damage, do
not connect the C Common Input COM Terminal to
any source of 1000 V DC/AC with respect to earth
ground.
-28-
Summary of Contents for 3335
