Peak Peak 632A, User Manual

Page: 42 / 137

PEAK 632A User Guide
BIOS Setup
4-
12
CPU Internal Cache/External Cache
These two categories speed up memory access. However, it depends on CPU/chipset design.
The default value is Enable. If your CPU without Internal Cache then this item
PU
Internal Cache” will not be show.
Enabled Enable cache
Disabled Disable cache
Quick Power On Self Test
This category speeds up Power On Self Test (POST) after you power on the computer. If it
is set to Enable, BIOS will shorten or skip some check items during POST.
Enabled Enable quick POST
Disabled Normal POST
Boot Sequence
This category determines which drive computer searches first for the disk operating system
(i.e., DOS). Default value is A,C.
C,A System will first search for hard disk drive then floppy disk drive.
A,C System will first search for floppy disk drive then hard disk drive.
Note: This function is only available for IDE type. For SCSI type is always boot
from A.
Boot Up Floppy Seek
During POST, BIOS will determine if the floppy disk drive installed is 40 or 80 tracks.
360K type is 40 tracks while 760K, 1.2M and 1.44M are all 80 tracks.
Enabled BIOS searches for floppy disk drive to determine if it is 40 or 80
tracks. Note that BIOS can not tell from 720K, 1.2M or 1.44M drive
type as they are all 80 tracks.
Disabled BIOS will not search for the type of floppy disk drive by track
number. Note that there will not be any warning message if the
drive installed is 360K.