Cyclone Automated Control Package
47
SETRESETDELAY=resetdelay
Specifies the amount of reset delay used when a Cyclone unit is
reset using the “ALLRESET” or “RESET” commands. “resetdelay” is
the number of milliseconds to delay, and must be greater or equal to
5500. Increasing this delay is important if using the USB interface,
which requires extra time to reenumerate when the Cyclone is reset.
OPENTYPE=x
Specifies whether Cyclone units will be identified by IP address or by
device name. Both of these Cyclone parameters are reconfigurable
by the user.
The value of x may be:
IP
- Cyclone units will be identified by their IP addresses
NAME
- Cyclone units will be identified by their device names
PORT_NUM
- Cyclone units will be identified by their port
