7
OPERATION GUIDE
The PCTEL AP-WiFi-1200 is designed for ease of setup and configuration. Out of
the box, only settings that are particular to system integration need to be changed
as needed. A Web User Interface is provided for access to all system settings.
Several typical changes are shown below. See
Section 3.5
for details on the
Console Interface.
The pushbutton switch provides two functions. A momentary press of the button
will indicate WPS mode. Holding the button for at least five seconds will reset the
access point to factory settings.
The access point status is provided by the LED Status Indicator built into the
weatherproof pushbutton switch. After power is successfully applied, under normal
operation, the LED Status Indicator is green.
Note:
This unit can only be configured to operate as an access point. Since the
access point can be installed either indoors or outdoors, it can be operated as either
an indoor or outdoor access point. Client mode and bridge mode are not currently
supported. The unit cannot be configured to operate in either of these two modes.
3.1. Packing List
•
AP-WiFi-1200 Access Point
•
Antennas
-
(3) 2.4 GHz 6 dBi Omni Antenna - Part Number BOA24006NM
-
(2) Dual band 7 dBi Antenna (for 5 GHz radio) - Part Number MHODB24490507NM-IP
•
Phihong POE29U-1AT(PL)D-R Power Injector
•
Ethernet Cable
•
Console Cable
•
Installation Accessory Kit - Part Number 11-1110-01
•
Mount Kit - Part Number 11-1109-01
3. Setup and Configuration
