Brought to you by PCS Electronics, www.pcs-electronics.com
WINDOWS CONTROL PROGRAM
SOFTWARE INSTALLATION AND COMMUNICATION SETUP
Use the USB port!
Our processors have two USB ports, one serves as USB audio input. That one should not be used for remote control!
Installing USB driver
If you want to use USB to program and control our transmitter via PC, download the USB COM port driver, you can find
it
here
:
https://www.pcs-electronics.com/shop/fm-transmitters/cybermax-fm-transmitters/cybermaxfm-se-v3-15w-and-
25w/
(look under additional information tab)
Download the USB driver for your operating system and run the setup file. Wait for the following screen (or very similar) to
appear and select the installation directory (best left alone at default location). Click Install and wait for the installation to
finish.
Installing USB driver
Configuring USB driver
In Windows go to Start > Settings > Control Panel > System > Hardware tab > Device Manager (This can vary depending on your Windows version). You
should have something like this on your screen at this point:
Configuring Com port for USB driver
Take note of the COM port number here, you will need it later to configure the COM port inside Cyb control
program for Windows. If you wish to change this port right click on the PCS USB-COM or whatever Windows detected it
Chapter
6