Erwin XL
Ultralight Electro
- building Instruction
August 2018
www.pcm.at
8
7. Electronic components (electric gear) inside the fuselage
Glue the
installation frame for the engine
with UHU 300
endfest or Pattex Stabilit into the fuselage.
The tip of the fuselage cone is
ready prepared for correct
mounting
of the engine. Just glue the frame
flush with
the cut
of the fuselage.
Note that the
screws
are positioned
up, down, left and
right
. So you can correct the mounting of the engine later
by adding thin washers.
As there is no space for the
receiver
in the fuselage cone,
it is placed
behind the wing joiner
.
For reception of
2,4GHz
you can drill holes on the rear
lower end of the connecting rib to the wing to
lead out the
antennas.
Insert
plastic tubes
inside these holes. You can easily
thread the antennas through these tubes later.
The tubes should be long enough …
