© PCE Instruments
2. The locking lever can be turned to the left side. By doing so, the camera head will
remain in the position that has been selected before. It can be loosened by turning
the locking lever to the neutral position in the middle. The camera head can then be
moved again.
10.2
HR borescope cable
In addition to the general safety notes of the device, please mind the following safety notes to
prevent damage and injuries when using the HR camera cable.
To avoid dangerous situations, make sure that the probe does not get in touch with
inflammable liquids or gases.
The HR cable includes various small cables which control the optics and
electronics of the camera tip. To ensure high reliability, do not bend the cable to an
angle of more than 90 ° and store the cable as little bent as possible.
Do not disassemble the device as this can cause damage and electric shocks.
Do not expose the device to direct sunlight and store it in a cool, dry, sufficiently
ventilated place.
To protect the camera module, make sure the protection ring is on the camera
head as long as no accessories are in use.
Do not apply force to the end of
the cable and do not bend it.
This can deteriorate your vision
and even damage the probe.
