EN - 17
4. 5
Tolerance limits
The tolerance limits can also be set for good/not good measurement. If you activate the alarm and set up a valid
limit, the
icon will be displayed for values within the limit, the
icon for values below the lower limit and the
icon for values that exceed the upper limit.
4.6 Zeroing
Press ZERO/▲ to clear the force gauge in Track mode, i. e. to remove the tare.
4.7
Hand-held or test stand operation
The force gauge is a portable instrument, which means that you can carry out measurements by holding the device
in your hands, or you can install the force gauge to a test stand to obtain more accurate measurement results.
There are 4 x M5 mounting screw holes at the back by means of which the force gauge can be fixed to a test stand.
4.8
Memory
Measurement results can be saved to the internal memory of the force gauge so that you can review or print them
later. Press the SEND/EXIT key to save measured values and the
icon will be displayed.
4.9
Test method
During measurement, the device and the object to be measured must form a straight line.
E
n
g
lis
h
Summary of Contents for PCE-DFG 500
Page 13: ...IT 13 Italiano...
Page 23: ...EN 23 English...
Page 24: ...Specifications are subject to change without notice...
