Manual
11
6.4.8
Restore factory settings
After you got to the point
“DSET”, press C to choose between “ESC” to abort and “rdS” to restore the
factory settings. By pressing “C” you confirm your selection.
6.4.9
Return to measurement mode
Press “M” once again to return to the measurement mode. The durometer will display “000”.
6.5
Measurement
1. Press the release button on top of the durometer to switch it on.
2. Push the roll pin in the slot of the hydraulic impactor until the hydraulic impactor until it locks.
3. Press the durometer tightly onto the surface that is to be measured.
4. Press the release button on top of the durometer to perform a measurement. The measured
value is indicated on the LCD.
