Working with control panel
17/29
“
for minimum current
” line. Enter new value and press
(fig. 18). Press
and
in the “
Current output settings
” to apply and check new
settings. The moisture content value corresponding to the minimum current can be
changed in similar way.
fig 18. Adjusting current output settings
A315 sensor can perform measurements in mode
or
.
Moisture calculation in “Mode AF” is performed using two algorithms. Calculation al-
gorithm is selected automatically by the sensor depending on grain moisture content
and temperature. Selected method is indicated with number “1” or “2” in “
Moisture
”
line. Both algorithms allow to apply correction coefficients.
Fig. 17 shows figure “1” in “
Moisture
”
line with measured moisture content value
reading 13.3 %. It means that moisture calculation is performed using algorithm “1”
and only correction coefficient “
1 Offset
” is valid for this algorithm.
fig 19. Entering correction for algorithm 1
If for grain sample with known moisture content, for example, 13.8% the sensor
reads 13.3 %, then the correction of 0.5% must be applied. To input correction press
