PCB Piezotronics Larson Davis EPS044, Reference Manual

Page: 13 / 57

NMS044 Reference Manual Rev E Overview 2-1
Module 2 Getting Started
2.1 Overview ..............................................................................................................................2-1
2.2 Preparing the Battery ..........................................................................................................2-1
2.2.1 Installing the Battery ............................................................................................2-1
2.2.2 Charging the Battery .............................................................................................2-2
2.3 Obtaining Cellular Service for the RV50X ...........................................................................2-2
2.3.1 Installing the SIM Card ..........................................................................................2-3
2.4 Configuring for Remote Communication ...........................................................................2-4
2.4.1 Configuring the Gateway for Remote Comms Using USB ...................................2-4
2.4.2 Configuring the Gateway for Remote Comms With a Mobile Device .................2-7
2.4.3 Enabling the Trusted IP (Friends) List ..................................................................2-7
2.5 Configuring SLM Settings On the 831C ...............................................................................2-8
2.1 Overview
When you receive the NMS044 system you will need to perform several “first use”
procedures. While most can be done in the field or after deployment, we highly
recommended completing this section before deploying.
TAKE NOTE
This module assumes that you have the complete NMS044 and all its components. The
setup is similar for the EPS044, and the following modules apply to that system as well.
2.2 Preparing the Battery
In this section:
•
2.2.1 Installing the Battery
•
2.2.2 Charging the Battery
2.2.1 Installing the Battery
TAKE NOTE
Connect all wires and devices prior to turning on the system.
Step 1
Open the case and lift out the plate being careful not to pull any
wires loose. Set on an angle away from case.
Step 1
If not already in place, insert the battery (BAT019 or BAT020) in the
case inside the guide lines, with the terminal toward the power
block. See Figure 2-1 Battery Installation .
Step 2
Insert the connectors to the power distribution block—red to red and
black to black—side by side in any available connector.
Step 3
Place the mounting plate back into the case, over the battery, until
set all the way in.
Step 4
If installing a BAT020, insert foam block to fill empty space by the
terminals.