4
Turf Foam Marker Unit
1. If mounting the turf foam marker on a CropCare
®
sprayer, place it on the center of the boom frame (Figure
2). Attach the turf foam marker by using the included
3/8” carriage bolts to clamp the turf foam marker frame
around the main boom tube. The unit may be mounted in
either direction on the boom.
2. If mounting the turf foam marker on any other application,
begin by choosing a convenient location that is easily
accessible for mounting and filling the solution tank. The
turf foam marker should be mounted in the center of the
machine so both discharge hoses are the same length, and
where it will receive a minimal amount of dust or dirt.
3. The mounting location must be able to support the weight
of the turf foam marker unit with a full solution tank.
4. Secure the turf foam marker unit by attaching the turf
foam marker frame to your equipment. Use the included
3/8” carriage bolts and flange nuts. Insert the carriage
bolts through the four square holes, which are located
on the bottom of the turf foam marker frame, and secure
them with the flange nuts.
1. The compressor wiring harness (a) has a 2-pronged plug.
This wiring harness needs to be connected to the switch
wiring harness (b) which includes the control switch.
Make sure the colors match (Figure 3).
2. The switch wiring harness (b) needs to be connected to
the battery wire harness (c) which includes the 15 amp
fuse (d). Make sure the colors match (Figure 3).
3. The battery wire harness needs to be connected to
a 12 volt DC power source. Connect the red wire to
a positive power source either at the tractor's battery
terminal or at a power access point with at least 15 amp
capability. The black wire needs to be connected to a
good ground source or to the negative terminal of the
battery.
4. Ensure that the power source is adequate, since an
inadequate power source could cause numerous problems
with the turf foam marker unit. If you are using a power
access point, ensure that it has at least 15 amp capability.
5. You now need to place the switch in a location where it is
easily accessible for operation. Secure it so that it cannot
fall or become entangled and cause damage.
Wiring Harness
Figure 2: Turf Foam Marker Unit Mounting
Boom Frame
Figure 3: Wiring Harness
a
b
c
d
Mounting the Turf Foam Marker
