“
SAS Super IAQ” Rev. 1 Pg.
1
ENGLISH
SECTION ONE
•
BRIEF OPERATING INSTRUCTIONS FOR SAS SUPER IAQ
The air flow is displayed after the automatic presentation each time the instrument is switched
on.
Press ON/OFF switch.
Press START button to sample the same air volume of the last sampling cycle.
To change the air volume, use the arrow buttons and select “User Mode” from menu.
Refer to instruction manual to change settings.
Press ENTER to confirm selection.
Press arrows for menu selection to modify other pre-set parameters:
USER MODE
PROGRAM MODE
DELAY MODE
UTILITY MODE
Press ENTER to reach the sub-menu of the chosen parameter.
Refer to instruction manual to change settings.
Press ON/OFF switch at the end of sampling operations.
Press “CLEAR” each time you need to end an action. Then the unit will come back to the initial
configuration.
•
VISUAL DISPLAY PRESENTATION
(Press ON/OFF black button switch).
Each time the ON/OFF switch is pressed, a ten seconds visual display presentation will appear
displaying the following information:
(1) INTERNATIONAL
PBI
(2) S/N XXXX
Rev. XXX.XX (Firmware revision)
(3) PRESS ARROWS
FOR NEW MENU SELECTION
(4) SAS SUPER IAQ
(5) ID XXXX
SITE XXXX
(6) START FOR XX
MM/DD/YY - HH/MM
This information are displayed
automatically
. Avoid pushing any button before the end of the
few seconds presentation; during this presentation all functions are disabled.