“
SAS Super IAQ” Rev. 1 Pg.
26
ENGLISH
7.2 Sampling time required for different air volumes
SAS SUPER IAQ
LITRES OF AIR
TIME REQUIRED
50
30 seconds
100
1 minutes
200
2 minutes
300
3 minutes
400
4 minutes
500
5 minutes
600
6 minutes
700
7 minutes
800
8 minutes
900
9 minutes
1000
10 minutes
7.3 Battery charger operations
When the message LOW BATTERY is flashing, the air sampler must be recharged.
1. Switch off the unit.
2.
Connect the smaller plug of the battery charger to the battery socket on the SAS SUPER
IAQ
3.
Connect the battery charger to the main supply (220-240 or 110 Volts): verify that the
LEDS on the charger are lit correctly (see label on charger).
4.
The air sampler is recharged after 14 hours using the normal battery charger “Revit“
(Cat.n. 19248) or after 3.5 hours using the fast battery charger (Cat.n. 88603).
5.
Disconnect the battery charger from the mains supply.
6.
At the end of operation, disconnect the battery charger plug from the socket of the air
sampler.
NOTES
(a)
The correct metal hydrate battery charger must be used to charge the SAS SUPER IAQ !
(b)
If the air sampler has not been used for several weeks, check the battery status!
(c)
The efficiency of the battery is reduced when operating at temperatures below 0°C.
(d)
This battery pack, using the SAS SUPER IAQ sampler, should provide approximately 5-
7 hours of sampling time.
Before using for the first time, or after a storage time of one month or more, charge
battery for 14 hours. If you do not reach the rated battery capacity during initial use,
repeat the 14 hours charge process.
Do not charge the battery for more than 24 hours.