Payne OG-PG9M-07, User'S Information Manual

Page: 9 / 16

9
21 22 23
4. Remove air fi lter from furnace.
• AIR FILTER(S) LOCATED IN END OF FURNACE:
a. Slide air fi lter retainer sideways until it is free of latch. (See Fig. 24.)
b. Slide air fi lter out of furnace. (See Fig. 25.)
24 25
• AIR FILTER LOCATED IN SIDE OF FURNACE:
a. Remove air fi lter retainer from latch. (See Fig. 26.)
b. Gently remove air fi lter and carefully turn the dirty side up (if dirty) to avoid spilling dirt from the fi lter. (See Fig. 27.)
26 27
5. Inspect the fi lter. If torn, replace it.
NOTE: If washable fi lter that was shipped with the furnace has been replaced with an electronic air cleaner (EAC), refer to the EAC
Owner’s Manual for maintenance information.
6. If washable fi lter, wash fi lter (if dirty) in a sink, bathtub, or outside with a garden hose. Always use cold tap water. A mild liquid
detergent may be used if necessary. Spray water through fi lter in the opposite direction of air fl ow. Allow fi lter to dry.
7. Reinstall clean air fi lter.
8. Reinstall fi lter retainer.
9. Replace blower access panel and main furnace door with two screws. (See Fig. 28 and 29.) Turn on electrical supply to the
furnace. (See Fig. 30.)