Paxar Monarch 9414, Equipment Manual

Page: 6 / 44

1-2 Getting Started
Keep all packaging material in case you need to move
or return the MRD system.
S e t t i n g U p t h e S y s t e m
CAUTION
Do not touch the electrical connectors while setting up
the printer. Electrostatic discharge can damage or
destroy the printhead or electronic components.
1.
Remove the tray from its packaging. Check inside
the packaging for the adhesive feet. Remove the
feet from their adhesive backing and apply one to
each corner.
2.
Place the tray on the cut table near an electrical
outlet.
Tray design may vary from the one
shown in this manual.
3.
Make sure the power on the printer is turned off
before setting up any cables. The power switch
on the back of the printer should be in the OFF
(O) position.
Adhesive
Feet